Whirlpool DESIGN 2000 Washer User Manual


 
I
I I’
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l
Push Control Knob in.
l
Turn clockwise to any’on the dial.
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected level
with cold water, agitate 2 minutes,
drain and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 and 7.
For a soak or pre-wash
For best results, use
warm
water
for soaking or pre-washing stained
laundry.
Hot water can set stains.
l
Use recommended amount of
detergent or pre-soa k product.
l
Push Control Knob in.
l
Turn clockwise to point at a
number
in the SOAK Cycle...use the bminutes
mark for a prewash.*
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle.
The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additlonal care
information on page 7 of your
“Laundry Guide!’
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.