Filter
Top Products
9
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
AB
A. Snap either end of the drain hose form to the drain hose
at the point where the corrugation begins.
B.Bend drain hose over drain hose form and snap into place.
To keep drain water from going back into the washer:
■ Do not straighten the drain hose, and do not force excess drain
hose into standpipe. Hose should be secure, but loose enough
to provide a gap for air.
■ Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor drain
under “Tools and
Parts.”
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secur
e the drain hose to the laundry tub leg or standpipe with
the beaded strap provided.
(See illustrations A and B.)
AB C
If the washer faucets and the drain standpipe are recessed
(see illustration C), put the hooked end of the drain hose in
the standpipe. Tightly wrap the beaded strap around the
water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.
Level the Washer
Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness
of the washer by placing a level on the
top edge of the washer, first side to
side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step un
til washer is level.
2. Make su
re all four feet are stable and resting on the floor.
Then check that the washer is perfectly level (use a level).
3. After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four fe
et must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4. The washer should not move front to back, side to side,
or diagonally when pushed
on its top edges.
5. Slide the washer to its final location.
6. Co
nfirm the levelness of the washer.
Complete Installation
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.”
2. Ch
eck that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Ch
eck that the water faucets are on.
6. Ch
eck for leaks around faucets and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
re, or electrical shock.
WARNING
7. Plug into a grounded 3 prong outlet.
8. Read “W
asher Use.”
9. T
o test and clean your washer, make sure there are no clothes in
the washer and add one AFFRESH
®
tablet to the washer drum.
Select Power, the Clean Washer cycle and then select START.
This cycle will take approximately 65 minutes to complete. Allow
th
e washer to complete the entire cycle without interruption.