Filter
Top Products
8
2. Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt.
3. Once all 4 bolts are removed, discard bolt and spacers. Then pull
the power cord through the opening of the rear panel and close
the hole with the attached cap.
4. C
lose the bolt holes with the 4 transport bolt hole plugs.
NOTE: If the washer is to be transported at a later date, call your
local service center. To avoid suspension and structural damage
to your washer, it must be prope
rly set up for relocation by a
certified technician.
Connect the Inlet Hoses
1. Insert new flat washers (supplied) into each end of the inlet hoses.
Firmly seat the washers in the couplings.
AB
A. Coupling
B. Washer
2. Make sure the washer drum is empty.
3. Attach
the hose with the red color indicator to the Hot (left) inlet
valve. Attaching the red coupling first makes it easier to tighten
connection with pliers. Screw on coupling by hand until it is
seated on the washer.
4. Attach the hose with the blue color indicator to the Cold (right)
water inlet valve. Screw on coupling by hand until it is seated
on the washer.
H
C
H. Hot water inlet
C. Cold water inlet
5. Usin
g pliers, check the tightness of the hose couplings already
attached to the washer.
NOTE:
Do not overtighten. Damage to the coupling can result.
6. A
ttach hot water hose to the hot water faucet. Screw on coupling
by hand until it is seated on the washer.
7. Attach cold water hose to the cold water faucet. Screw on
coupling by hand until it is seated on the washer.
8. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
9. T
urn on the water faucets and check for leaks.
NOTE:
Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks,
cuts,
wear, or leaks are found.
Connect the Drain Hose
Remove drain hose from washer drum
1. Use locking plie
rs, squeeze hose clamp tabs together and insert
over the end of drain hose.
2. Slide drain hose onto washer connection.
3. Once drain hose is in place, release pliers.
4. W
asher drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub.