Filter
Top Products
7
Venting
If the washer/dryer is not properly installed
and vented, it will not be covered under the
warranty.
NOTE: Service calls caused by improper
venting will be paid for by the customer,
whether it was a paid installation or self-
installed. For paid installation, call the
company that installed the vent for
adjustment.
1. Do not use plastic vent or flexible metal
foil vent. Use four-inch heavy metal or
flexible metal vent. Do not kink or crush
flexible metal vent. It must be completely
extended to allow adequate exhaust air to
flow. Check vent after installation. Refer
to your Installation Instructions for proper
length requirements of vent.
2. Use a 4" exhaust hood. Smaller hoods
increase drying times.
4"
Checking Your Vent
Your washer/dryer must be properly installed and vented to achieve maximum drying
efficiency. Install your washer/dryer in a well-ventilated room where the temperature is always
above 45°F (7°C). Also make sure that your washer/dryer is leveled. Refer to your Installation
Instructions for more information.
4"
4"
continued on next page
wWARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death or fire.