Filter
Top Products
13
OPERATING YOUR WASHER
Fill
▼
Wash*
▼
Drain-No agitation*
▼
Spin
▼
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected water level) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita-
tion starts, the Cycle Control Knob turns
clockwise until it points to Off and the
cycle ends.
Fill
▼
Rinse
▼
Drain-No agitation
▼
Spin-Spray rinse
▼
Spin
▼
Off
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the Normal and Permanent
Press cycles.
WASH RINSE
*Agitation speed is reduced in the last few
minutes of most cycles. This provides
better fabric care.
*The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
Self-cleaning lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
Self-cleaning
lint filter
Basket
interior