Filter
Top Products
4
. Attach 3/4” U.L.-
listed strain relief (U.L.
marking on strain
relief) to the hole
below terminal box
opening (see Figure
12). Tighten strain
relief firmly to cabinet
so it is in a horizontal
position. Place direct (outside dryer)
wire cable through
the strain relief.
Figure 12
,i$ 5
. Remove the center terminal
..!, !! ,: block screw, Remove the neutral
,Y - i green with yellow stripe ground wire
::. :. :
i - ‘! from external ground conductor
.! :
j ;, ; screw. Connect neutral green with
. . !: yellow stripe ground wire and the
;.;.j..; neutral wire (white or center) of
$j ! direct wire cable under the center
$I:‘:.: screw of terminal block. Place the
$;i:i:i. hook-shaped end of the wire over
:.$$< the terminal block screw with open
‘:$:.: side of the hook facing to the right.
Ii:; i Squeeze hook end of wire together
! I
._ ; to form a loop.
Z$.ii j Connect the other two insulated
;:;si..i wires under outer terminal block
I: i. screws. Attach wires using the same
$ ;.I method as the neutral wire.
..j.$ ; Connect the direct wire cable (bare
.; .;
f; :; ground wire to the external ground
: 1 conductor screw (see Figure 13).
.: i. Tighten all terminal block screws
:,; j : firmly.
neutral green with yellow
stripes (attached at
~; z jexternal
factory)
Figure 13
strain relief screws.
. Insert tab of terminal block
:.i :I. cover into slot of the dryer rear
i’ ‘$. panel (see Figure 1 1). Secure cover
/z-i. with hold-down screw.
. . . . ::
B.
Where local codes permit
connecting frame-ground
conductor to the neutral wire:
This dryer is manufactured with the
frame-ground conductor connected
to the NEUTRAL (center) of the wiring
harness at the terminal block. If local
codes do Not permit this type of
connection, use “Four-wire
connection” instructions.
Electrical Shock Hazard
Turn power supply off before
connecting cord.
rounded outlet.
1
. Turn power supply off.
2
. Remove hold-down screw and
terminal block cover.
external ground
hold-
3
. Attach 3/4” U.L.-listed strain
relief (U.L. marking on strain relief)
to the hole below terminal box
opening (see Figure 15). Tighten
strain relief firmly to cabinet so it is
in a horizontal position. Place
power supply cord through strain
relief.
strhin relief
(outside dryer)
Figure 15
#i: 4
. Loosen or remove terminal
: :
: block screws. Connect the neutral
: :
: : wire (white or center) of power
: 1
:. j
supply cord under the center screw
: ; ,; of the terminal block.
’ ,: : Connect the other two wires to
: :
: : outer terminal block screws (see
: j : Figure 16).
: :
: :
:
: :
Tighten all terminal block screws
j : firmly,
: :
: :
Center wire MUST be connected to
:
: c
center screw.
: :
:. .:
: :
: :
: :
: :
external ground
: :
: c
:
:
strain relief
screws
: :
! :
Figure 16
i. 5
. Tighten strain relief screws.
6
. Insert tab of terminal block
: cover into slot of the dryer rear
panel (see Figure 14). Secure cover
with hold-down screw.
: :
: :
: :
:::
: :
:
Page 8