to clear
ratchet tooth.
4. Insert a narrow, flat-blade
screwdriver under the timing cam
near the clock shaft. Gently lift cam
stralght up and off shaft maklng sure
that the “V-shaped notch clears the
ratchet tooth.
5. Place new cam (hub side down)
over clock shaft. Line up flat side of
shaft with flat side of cam hole.
Check that drive lug is in place,
6. Turn cam until “Y-shaped notch
lines up with ratchet tooth.
7. Press cam down in place on motor
shaft. Make sure that Y-shaped
notch clears the ratchet tooth,
8. Reattach the timer bracket
assembly; tighten the screws.
9. Repeat steps for other timer.
10. Close and lock the control panel.
Now start...
With dryers in laundry area.
1
n
Put on gloves and safety glasses.
Check that each leg is approximately
2.5 cm (1 inch) from base.
2.
Wipe the interior of the drums
thoroughly with a damp cloth.
3.
Install coin vaults and locks (not
supplied) into meter case openings.
4.
Install control panel lock and key (not
supplied).
5.
If you wish to change the 45-minute
dryer timing cams to either 30- or 60-
minute timing cams, see “To change
to a 30 or 60-minute timlng cam,”
Pages 7 and 8. Complete all of the
steps given in that section before
going to Step 6.
Open control panel and rest it on the
bottom edge of the opening. Attach
slide extension (with flange pointing
down) to one of the coin-slide
mechanisms. Insert the coin-slide
mechanism through the opening to
the left of the control panel.
7.
Secure coin-slide mechanism from
inside the control panel using the
3/16” bolt and washer supplied. Install
coin box.
8.
Repeat Steps 6 and 7 for the other
coin-slide mechanism. Close control
panel,
l
i
9.
Insert top of wire guard into holes on
each side of the coin-slide
mechanism. Insert screws through
hooked ends of guard and tighten.
Repeat for other wire guard.
Page 8