Filter
Top Products
Ocmj
(0”)
closet side
view
-B.
0
Additional space may be needed for
exhaust elbow. Additional clearances fog
wall, door and floor moldings may be
required.
closet
door
front
view
~~;~~qinc;
. .
154.8 sq cii
(2P sq. in.2
0
h-
7.6 cm
WI
T
+
7.6 cm
w
T-
Opening is minimum for closet door.
Louvered door with e
9
uivalent air
openings Is acceptab 8.
Corn
P
anion appliance spacing should be
cons dered.
No other fuel-burning appliance may be
installed in the same closet.
Product dimensions
F’
I
side
view
191 CI
(75-l/
n
‘4”)
c
-
approx,
2.5 cm
(1”)
rear
view
I3
34.9 cm
(13-314”)
2.5 cm _
J
(1’3, IFi&
-4
.-.-. .-
et
118.7’cm I,
cm
cm (4”)
17.1 cm
(6-314”)
To than e to a
$
30- or 6 -minute
timing cam
Electrlcal Shock Hazard
Disconnect both power supply cords
betore changing timer cams.
Failure to tallow thls lnstructlon could
result In death or serlous Injury.
Each dryer is equipped with a 45
minute tlmer cam that provides 45
minutes of drying time when
activated by the coin slide.
You can install the 30-minute or 60
minute timing cam (shipped with
each dryer) as follows:
1. Unlock control panel. Lift up and
rotate out from cabinet. Control
panel will still be attached to cabinet.
2. Reach into control panel area. Use
a Phillips screwdriver to loosen @ut
not remove) timer mounting bracket
screw. Lift up to remove timer
assembly and bracket from cabinet.
timing cam
3. Turn the timing cam by hand until
me “W-shaped notch lines up below
me ratchet tooth.
Page 7