Filter
Top Products
Recessed
and closet
installation
instructions
Fire/Health Hazard
l
Exhaust the dryer to the outside
to prevent exposure to
substances in the gas fuels
and combustion which may be
harmful to your hwlth.
l
If dryer is installed in a closet,
the dryer MUST be exhausted
outside.
Failure to do so may result in
a fire.
-he following installation spacings
‘2nd door air openings for the
:ompact dryer are possible when
nstalled with or without the Stack
?ack Kit LCK 1100 and exhousted
JS noted. (Spacing as indicated is
n inches and is minimum allowable
-or ease of installation and sewice,
additional spacing should be
:onsidered.)
Recessed
front view
?
*I 1
tl-min
Closet
closet
Front view Side view
TO PREVENT LARGE AMOUNTS OF
LINT AND MOISTURE FROM
ACCUMUlAllNG AND TO MAINTAIN
DRYING EFFICIENCY, THIS MACHINE
MUST BE EXHAUSTED OUTDOORS.
’ Addhnal cleorancer tar wall. door and floor
moldw$ may be rs-wwx
“Opening is minimum for closet door louvered
door w~,h eqwalent cur openings LI occeptoble
“‘Add,hono, space LS needed when external exhaust
elbow IS used
Companion appliance spacings
should be considered.
Detalled space requirements can
be found on the label located on
the back panel of dryer.
NOTE. No other fuel burning
appliQnce may be Installed in
the same closet
If drver does
not dperate
*
properly...
If dryer will not operate, check the
following to be sure that:
A. Electrical supply is connected.
B. Fuse is intact and tight.
C. Door is closed.
D. Controls are set in a running or
“ON’ position.
E. Start button has been pushed firmly
or the power control lever moved
upward to start.
F. Gas shutoff valves are open both on
dryer and on supply lines.
When moving the dryer...
l
Disconnect the electrical cord and
grounding wire and tape securely
to dryer.
l
Shut off the gas supply valve controls
in the gas supply line.
l
Disconnect gas pipe fittings from
dryer and cap the gas supply line
l
Tape the drum to the front panel
Tape the dryer door, int screen lid
and end of gas pipe.
l
Screw leveling legs all the way in.
Before installing your dryer in your new
home, check with your gas supplier or
dealer to see that your dryer is
equipped with the correct burner for
the particular type of gas in your new
home Burner information may be
found on the rating p’gte in the door
well of the dryer.