Filter
Top Products
8
• The washing machine has completed the
programme: this is indicated by a flashing zero
.
Important!
The first time you use the washing machine, when
you switch it on, it may display a flashing zero. This is
due to the fact that the washing machine has performed
a washing cycle during the manufacturer’s inspection
tests, and this cycle has not been erased after its
completion.
• An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 22-23).
E20
0
8
“Dry time” button
By depressing this button you can select a timed
programme for cotton or synthetics, the relevant light
illuminates.
For C
OTTONS and SYNTHETICS you can select a
drying time from 10 minutes to 130 minutes (
2.10).
Every time you press the button the time increases by
5 mins.
10 “start pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
10 Programme phase indicator
lights
When you select a programme, all the pilot lights are off.
After you have pressed the start pause button (the
washing programme starts), the “wash” light illuminates.
end
dry
wash
60
dry
time
time