Filter
Top Products
Filling the Iron
DO NOT use water containing softeners, perfumes or additives as these may
damage the iron irreparably.
Unplug the iron from the mains. Set the Steam Control to OFF.
Lift up the water ller cap. Be careful not to use excessive force or you may damage
the hinge.
Fill carefully with fresh
water using the supplied
ller cup.
Do not ll the iron above
the MAX mark indicated
on the side of the iron.
Close the cap
Operation
Ensure the mains socket is switched o at the wall and the Steam Control is OFF.
Fill the iron with water as described above.
Place the iron on its heel on the ironing board rest and connect the power cord to
the wall socket.
Switch on the power. The pilot light will illuminate.
Select the correct temperature.
Turn clockwise to increase
and anti clockwise to
reduce temperature.
The pilot light will turn ‘OFF’ when the indicated setting reaches the correct
temperature. The iron is now ready for use.
During use the indicator will come on and o as the thermostat maintains the iron
at the correct temperature setting.
Note: Some parts have been lightly greased and the iron might smoke slightly when
switched on for the rst time. After a short while, this will cease.
Before using your iron for the rst time: Pass the iron over a clean cotton cloth to
remove any residue.
Steam Ironing
Steam Ironing should be carried out at the highest settings on the temperature dial.
The quantity of steam is regulated by the Steam Control.
Move the steam control to a suitable position depending on the amount of steam
required and the ironing temperature.
Warning: the iron gives o steam continuously only if you hold the iron horizontally.
You can stop the continuous steam by placing the iron in a vertical position or by
moving the steam selector to MIN.
Basic Operation
Getting Started
MAX
INCREASE