Filter
Top Products
FOR YOUR OWN PROTECTION, AND TO PREVENT ACCIDENTS, INJURY AND FIRE, PLEASE READ
THE FOLLOWING CAREFULLY:
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric
shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
WARNING
-
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance.
If it will not fit the outlet, have
a proper outlet installed by a qualified electrician.
P
LUMBING (Water Inlet)
The straight end of these hoses should be connected to the
supply (Fig. 4). The 90° angled end of these hoses should be
connected to the inlet valves on the back of the machine,
using one of the washers to make a water tight seal on each
connection. The couplings should be tightened by hand, a
tool should only be used if a leak occurs.
Do not use excessive force (see M, Fig. 1).
The Inlet valves are color
-
coded:
Red = Hot
White = Cold
It is possible to run the machine on cold water only, but a
water supply must be connected to each inlet valve. To do
this we suggest you use "F" connector, supplied with the
washer-dryer (see N, Fig. 2).
PLUMBING (Water Outlet)
You should carefully position the drain hose to avoid kinks
and ensure proper drainage of the water.
The outlet end of the drain hose must be at least 20" (50 cm)
above the base of the machine. At this point it is possible for
the water to be discharged into a sink, standpipe or drainpipe.
No more than 6" of the drain hose should insert into a stand-
pipe. Assure an air break is available to prevent the machine
from siphoning in a standpipe.
MODELS: WDB1043
-
LWD1054M
-
WDC1025
-
WDC1025M
MODELS: WDS1043
-
SWD1054M
-
WDC1024
-
WDC1024M
Page 3
•
Destroy the carton and plastic bags after the washer-
dryer has been unpacked.
•
Children should never be left alone or unattended in
the area where appliances are located.
•
Washer installation and grounding must be done in
accordance with local codes by a qualified installer.
Installation instructions are included in this manual for
the installer's reference.
•
Use only low sudsing detergents suitable for front
loading washers, or a small amount of regular
detergent. The soap suds should never exceed the mid-
line of the port-hole.
•
The washer must be plugged into a properly grounded
three (3) prong electrical outlet. For your safety, the
third or round grounding prong must never be
removed. DO NOT USE AN EXTENSION CORD.
•
Repair or replacement of a part should be made only
by a qualified service technician to prevent personal
injury or damage to the machine. Ask your dealer for a
list of authorized repair service companies.
•
Disconnect power to the washer at the circuit breaker
or fuse box, or unplug the machine in an emergency,
or when servicing is required. Have the installer show
you and label the proper switch or fuse at the electrical
disconnect box.
WARNING
-
The Appliance Should Be Connected To
An Individual Branch Circu
it With No. 14 AWG
Wire And Protected By 15 A Fuse or Breaker.