With machine power OFF, pour ½ quart of RV-
type antifreeze into washer drum
Close door. Advance to a ‘Spin’
position
Press Button (IN). Wait 1-2 minutes
Press Button (OUT). Unplug washer-dryer
from electrical outlet (or disconnect power)
Turn water supply faucets OFF. Disconnect inlet
hoses from faucets. Drain remaining water from
the hoses.
If currently
pumping antifreeze
through a fresh water system
With machine power OFF, turn knob
to HOT
Advance to cycle
Press button (IN). Let machine fill until
antifreeze is in the drum
Advance to ‘RESET’. Wait 5
seconds
Advance to a ‘Spin’ position. Let
the antifreeze drain from the drum
Advance to ‘RESET’. Wait 5
seconds.
Press the button (OUT)
Turn knob to COLD
Repeat steps 2 through 7. .
Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON. NOTE: Check
water inlet hoses and pump periodically
Plug washer-dryer in to appropriate electrical out-
let- or reconnect power supply
With button in the OFF (OUT) position,
pour ½ TBSP. of powder detergent (or liquid
equiv.) into the ‘Detergent’ compartment inside
the Dispenser Drawer
Advance to cycle
Press button (IN). Allow machine to run
through complete cycle to clean out any remain-
ing antifreeze.
(for RV or marine installs)