Filter
Top Products
2. Attach the hose connected to the ‘H’ valve to the hot
water faucet. Screw on the coupling BY HAND until it is
seated on the gasket. DO NOT OVERTIGHTEN.
3. Attach the hose con-
nected to the ‘C’ valve
to the cold water faucet.
Screw on the coupling
BY HAND until it is
seated on the gasket.
DO NOT OVERTIGHTEN.
4. Turn on the water
faucets and check for
leaks.
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or
standpipe with a strap or cable-tie.
3. Use the U-Clamp (provided) and insert the drain hose
into the standpipe or sink. DO NOT force excess drain
hose into the standpipe. There should be only 6” of
drain hose in the stand pipe.
After positioning the washer in it’s final installation
location, you must level the washer.
The front feet are self
locking and adjustable.
Your machine will be
noisy if the two front feet
are not adjusted so the
machine stands firm and
level.
1. Tilt the machine
back, leaning it
against the wall.
2. Adjust the front feet up or down to ensure the
washer is resting solid and does not rock side-to-
side or front-to back when the machine is upright.
H
C
20" (50 cm) min.
with an air break
25" (62 cm) min.
34" (86 cm) max
.
6" max.
Standpipe
U-Clamp
SecureFit Brackets,
Part No. MKO1
• Hook around two front feet
and screw into the floor.
• Designed to keep the washer
from shifting front-to-back or
left-to right.
• Recommended for RV or
Marine Installations.