Filter
Top Products
Instructions for Use
56
Connection to Power Supply
Connect the appliance to the power supply with a
cable cord. The wall socket should be equipped
with an earth contact (safety socket).
Fixed connection should be carried out by an
expert.
Rated voltage, frequency and other data are
listed on the rating plate of the machine.
Your washing machine should be grounded
and connected to the power supply according
to local electricity board regulations and
standards.
WARNING!
In the supply cord is damaged, it must be
replaced by the manufacturer or his service agent
or a qualified person in order to avoid hazard.
• The appliance should be placed in the position,
where the plug is within reach.
The Door
The door can only be opened two minutes after
the washing programme has finished.
Open the door by pulling the door handle (fig. 9).
When closing the door, push it towards the
machine until it locks (fig. 10).
If the door is not correctly closed, the machine will
not operate.
IMPORTANT
• When closing the door, be careful not to trap
fabric between the door glass and the rubber
gasket.
• If you need to open the door after the machine
has been switched on, first switch it off and wait
for about two minutes.
When opening the door, be careful, as the
water level may be high and water may pour out
when you open the door.
• Don't even try to open the door while the
machine is operating.
• If the machine won't start after switching on,
push the door once again towards the machine
(at handle).
• An inadequately closed door is the most
common cause of malfunctions.
Direction of Opening the Door
Certain models of appliances allow the possibility
of changing the direction of door opening. This is
an option that has to be ordered separately and
paid for by the customer.
9
10