Filter
Top Products
▼ Allow a good quantity of water to flow out of
the system until it is clear and free of impurities,
especially if the plant is new or has not been used
for some time. Connect the water inlet pipe to
the valve, inserting the filter/washer supplied.
Check that the other end of the pipe is tightened
properly. Position the drain hose between a
minimum of 60 cm and a maximum 90 cm from
floor level.
N.B. To prevent siphoning, do not make the
machine drain hose connection air tight.
If the water system is not provided with a drain,
use the bracket supplied to position the drain pipe
over a washbasin then tie it to a tap.
Do not use old or used fill hoses. Use only those
supplied with the machine.
GB
4
▼ Place the machine near to the connection points and ensure that it is
level. To do this, adjust the feet by screwing or unscrewing them as required.
When the machine is level, tighten the lock nuts on the feet using a spanner.
▼ Check that the power supply and socket are
correctly sized for the maximum load demand of
your machine. The power supply voltage is indicated
on the rating plate affixed to the filter door on the
bottom right of the washing machine.
The mains electricity supply must be equipped with
an earth. If this requirement is not complied with, the
manufacturer will not be held liable for any resulting
damage or injury.
SETTING-UP THE MACHINE
ELECTRICAL CONNECTION
WATER CONNECTION
MIN. 60 CM
MAX.90 CM
A