Filter
Top Products
Wash programmes
Detergent drawer
Function buttons
On/Off light
Temperature knob (K)
Timer knob (P)
▼ Half-load button
Pressing this button will save water and energy when the wash load in the machine is
approximately half of the maximum allowed.
▼ No-spin button
Pressing this button will stop the wash cycle automatically (all programmes) without spinning.
▼ Anti-crease button
When this button is pressed, the machine will automatically stop with water still in the drum,
thus preventing the washing from creasing. Press the button again to complete the wash
cycle with a water drain and final spin.
N.B. this function is only enabled for the “delicates/synthetics” and “wool” programmes.
Detergent drawer
Compartments:
1. Prewash detergent
2. Main wash detergent
3. Softener
Add the detergent and softener following the doses recommended by the manufacturer.
Open the water fill valve. Select the required program by rotating the programmer knob
clockwise. Select the temperature using the temperature control (if present) according
to the load. Select the function buttons according to the model, then press the On/Off
button (where present) or pull the programmer knob outwards. The power on indicator
will light up. At the end of the wash cycle, press the On/Off button or, if this is not present,
push the programmer knob inwards. The power on indicator light will switch off. Wait
approximately 3 minutes before opening the door.
Temperature knob
This is used to set the temperature of the wash
based on the instructions in the programme table.
The knob can also be set at 0°C to allow a cold
wash.
▼ On/Off button
Pressing this button starts the washing machine once all the other necessary operations
have been carried out (see “Using the washing machine”).
▼ Economy wash button
This function limits lowers the temperature limit from 90°C to 60°C, while at the same time
increasing the intensity of the wash for loads of less than 3 Kg of dry washing.
GB
1
USING THE WASHING MACHINE
DESCRIPTION OF FUNCTIONS
Eco
1/2