Filter
Top Products
FAULT POSSIBLE CAUSE
REMOVING
METHODS
Excessive foam is
formed in the
detergent drawer.
Excessive amount of
detergent used.
Press on Start/Pause
button. To eliminate
foam formation, mix a
spoon of softener with
half litres of water,
and pour the mixture
in the detergent
drawer. After 5-10
minutes, press on
Start/Pause button
again. In next
washing operation,
decide the dose of
detergent as required.
Wrong detergent
used..
Use detergents
produced only for
automatic washing
machines in your
machine.
Unsatisfactory
washing result.
The contamination
degree of your
laundries does not
match the programme
you have chosen.
Select the programme
appropriate for the
contamination degree
of your laundries. (see
programme table)
Amount of detergent
used insufficient.
Adjust the amount of
detergent based on
the amount and
contamination degree
of your laundries.
Laundries in excess
of maximum capacity
put in your machine.
Load your machine
with laundries,
amount of which will
not exceed maximum
laundry capacity
44
CHAPTER
-
10: TROUBLESHOOTING