Filter
Top Products
Electrical connection
Your washing machine is set to 220-240V and 50Hz.
Water inlet connection
Your machine may have either a single inlet (cold) or double water
inlets (cold/hot) based on its specifications. White-capped hose
should be connected to cold water inlet and red-capped hose to
hot water inlet (applicable for machines with double water inlets).
To eliminate water leakages in points of contact, 1 or 2 washers
are provided in the hose package (applicable for machines with
double water inlets). Fit these washers to the ends of new water
inlet hoses on the side of the tap.
Connect the white-elbow end of the water inlet hoses to the white-
filtered water inlet valve on the rear side of the machine and the
red-elbow end to red-filtered one (applicable for machines with
double water inlets). Tighten plastic parts of the junctions using
your hand.
Flow of water with pressure of 0.1-1 Mpa will allow your machine to
operate more efficiently (0.1 Mpa pressure means that more than 8
litres of water will flow through a fully-opened tap per one minute).
Ensure that new water inlet hoses are not folded, broken, crushed
or their dimensions are not altered.
Connect new water inlet hoses to a ¾ , threaded tap.
If your machine has double hot water inlets, the temperature of hot
water inlet should not exceed 70°C.
10
CHAPTER
-
3:
SETTING UP
ELECTRICAL CONNECTION / WATER INLET CONNECTION