Filter
Top Products
ROUGH-IN DIMENSIONS
L
._---_267/8"
_1 (68.3 crn)
43/8"
1.2cm)
B ELECTRIC CONNECTION
REAR ViEW
13 1/2"
2 9116"---_
(6.5 cm)
3 314'
(9.5 cm)
3/8" (0.96 cm) DIA. GAS
m
43 5/8'
(11o.7cm)
I" (2.54 cm)
36"
DOOROPEN900
47 1/2"
(120.7 cm)
SIDE ViEW
4 318"
(11.1 cm)
OPTIONAL --_
VENTKNOCKOUT
,e_ 27'
(68.6 cm)
EZ3-
(9.5 cm)
(Figure 1)
UNPACKING
1. Using the four shipping carton corner posts (two on each
side), carefully laythe dryer on its left side and remove foam
shipping base.
To prevent damage, do not use the control panel
or coin meter housing as a means to pick up or move the dryer.
2. Return the dryer to an upright position.
REVERSING DOOR SWING
FOAM
SHIPPING
PAD
Your dryer is designed so the door swing may be reversed at any
time without additional parts. Conversion is accomplished by
transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
1. Open the dryer door. Remove the four hinge hole plugs from
the left side of the door opening. Place nearby for future
installation.
NOTE: You may need a plastic knife to help pull out the plugs.
Be careful not to scratch the paint.
,
Remove the four screws that secure the door hinges to the
dryer front panel (see below). NOTE: Remove one screw from
each of the two hinges first. Hold the door firmly before
removing the last two screws.
,
,
Rotate the door 180° and reinstall the door hinges to the dryer
front panel with the four screws.
Install the four
hinge hole plugs
in the open
screw holes on
the right side of
the door
opening.
REMOVE4 SCREWS
(ONE FROM EACH
HINGE FIRST)