Filter
Top Products
32_ washing a load of laundry
Connecting to the network using the WPS setting
• Samsung washers use PBC as the WPS type. Check if the current wired/wireless router
supports Wi-Fi Protected Setup™(WPS).
• Check if the wired/wireless share has a WPS button.
1. Press and hold both the Temp. and Start/Pause buttons
for 5 seconds.
2. Turn the Cycle Selector until “UP” is displayed on the
display panel and press the Start/Pause button.
If the connection is not established within 5 minutes,
“FUP” is displayed on the display panel.
3. Press and hold the WPS button of the wired/wireless
router that will be connected with the washer for 120
seconds or less to run the WPS function of the wired/
wireless router. If the WPS function runs, the wired/wireless
router automatically fetches the necessary information from
the washer and the washer is automatically connected to
the Internet through the wired/wireless router.
• How to use the WPS function of the wired/wireless router may differ depending on
the manufacturer. Refer to the user manual of the corresponding wired/wireless
router.
• Even after the WPS setup is complete, it may take some time until the actual
connection is established to allocate an IP address through DHCP (up to 5 minutes).
• Note that if you use a wired/wireless router that is not WPS-certified, the washer
may not be connected through Wi-Fi or a device that was connected to the wired/
wireless router may be disconnected.
• Please note that for some wired/wireless routers, if you press and hold the WPS
button for some time, the settings of the router may be reset.
4. If the washer and the wired/wireless router are properly
connected, the
indicator blinks on the display panel for
30 seconds.
5. Press the Smart Control button to finish the Smart
Control connection setup. When the setup is completed
normally, the
indicator blinks on the display panel with a
beeping sound.
If you press the Smart Control button when the washer and the wired/wireless router
are not properly connected, the invalid button sound is heard and the Smart Control
connection setup is not completed.
washing a load of laundry
CAUTION
WF455AG-03159A-03_EN.indd Sec5:32WF455AG-03159A-03_EN.indd Sec5:32 2012-08-31 12:31:532012-08-31 12:31:53