Filter
Top Products
30_ troubleshooting and information codes
PROBLEM SOLUTION
Fills with the wrong
temperature water.
Turn both faucets on fully.
Make sure the temperature selection is correct.
Make sure the hoses are connected to the correct faucets.
Flush water lines.
Check the water heater. It should be set to deliver a minimum
120°F(49°C) hot water at the tap. Also check the water heater
capacity and recovery rate.
Disconnect the hoses and clean the screens. The hose filter screens
may be plugged.
As your washer is filling, the water temperature may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
While your washer is filling, you may notice just hot and/or just
cold water going through the dispenser when cold or warm
wash temperatures are selected. This is a normal function of the
automatic temperature control feature as your washer determines the
temperature of the water.
Door locked or will not
open.
Press the Start/Pause button to stop your washer.
Your washer door will remain locked during the heating portion of the
Sanitize cycle.
It may take a few moments for the door lock mechanism to
disengage.
Does not drain and/or spin. Check the fuse or reset the circuit breaker.
Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
restriction, call for service.
Close the door and press the Start/Pause button. For your safety,
your washer will not tumble or spin unless the door is closed.
Load is too wet at the end
of the cycle.
Use the High or Extra High spin speed.
Use high efficiency detergent to reduce over–sudsing.
Load is too small. Very small loads (one or two items) may become
unbalanced and not spin out completely.
Leaks water. Make sure the door is firmly closed.
Make sure all hose connections are tight.
Make sure the end of the drain hose is correctly inserted and secured
to the drainage system.
Avoid overloading.
Use high efficiency detergent to prevent over–sudsing.
Has excessive suds. Use high efficiency detergent to prevent over-sudsing.
Reduce the detergent amount for soft water, small or lightly soiled
loads.
Non-HE detergent is NOT recommended.
troubleshooting and
information codes
WF350AN-02833B-01_EN.indd 30 2010-10-13 �� 10:20:31