Filter
Top Products
5-6
Part Name
Descriptive Picture
How To Do
Outer Tub
and Spinner(1)
1. After the above knock-down to
Drain Pump, do the following.
2. Remove screws holding the wire harness.
3. Remove the bolts (2ea,13mm) securing Rear Struts
to Cabinet Bottom.
4. Swing Struts up against Tub to make it easy to
remove Tub Assy.
5. Remove bolts (2ea each side, 13mm) securing
Counter Weights.
6. Remove the screw holding the wire harness.
7. Remove bolts (2ea each side, 13mm) securing Front
Struts to Cabinet Bottom and swing Struts up against
Tub..
8. Loop the wire harness and Water Pressure Hose out
of its retaining holders.
9. Remove screws (7ea) securing Rail Frame and take
it off.
10. Remove Clamp and Vent Hose.
11. Loop out Suspension Spring by lifting it up (each
side).
12. Take out Tub and put it on block supports (4” wood
blocks or their equivalents) to prevent shaft
damage.
13. Remove screws (10mm) around the perimeter of the
tub.
14. Separate Front and Back Tubs from each other.
15. Take out Spinner Drum.
16. Remove screws to disassemble Baffles.
* When assembling, make sure that Front and Back
Tubs are fastened up tightly. If not, it will cause water
leakage.
5-2. DISASSEMBLY