Filter
Top Products
1-4
■ How to Level the Unit
1.Select an installation place.
► Install the unit with 10cm or more
clearance from its surrounding walls.
2.Check if the unit is leveled.
► If the unit wabbles, adjust the leveling
legs.
3.Adjust the leveling legs.
1-2. Precautions upon Installation
► The 4 leveling legs should
touch the floor all together.
When the unit is not leveled
► Lift up the unit a little bit and adjust the shortest.
► Turn the leveling bolt counter clockwise as shown
in the picture above (The leveling leg gets longer.)
► Slide your Washer into
position.
► Level your Washer by
turning the leveling legs
in or out as necessary
by hand. When your
Washer is level, tighten
the nuts using
the wrench included
with your Washer.
► If you install your washer on
softfloor, you should place the
rubber cup under adjustable
eg. Before put rubber cup, please
remove film for double-side tape
attached on rubber cup.