Filter
Top Products
20_ washing a load of laundry
Child lock
The Child Lock function allows you to lock the buttons so that
the wash cycle you’ve chosen can’t be changed.
Activating/Deactivating
If you want to activate or deactivate the Child Lock function,
press the Temp.
and Rinse buttons at the same time for
3 seconds. “Child Lock ” will be lit when this feature is
activated.
When the Child Lock function is activated, only the
Power button works. The Child Lock function remains
on even after the power is turned on and off or after the
disconnecting and reconnecting the power cord.
Delay end
You can set the washing machine to fi nish your wash automatically at a later time, choosing a
delay of max 19 hours (in 1 hour increments). The hour displayed indicates the time at which the
wash will be fi nished.
1. Manually or automatically set your washing machine according to the type of laundry you are
washing.
2. Press the Delay End button repeatedly until the delay time is set.
3. Press the Start/Pause button. The “Delay End” indicator will be lit, and the clock will begin
counting down until it reaches the set time.
4. To cancel a Delay End function, press the Power button and then turn the washing machine
on again.
Stop&Add
When the washing machine is working, the door is locked, and the “Stop&Add” lamp is off,
you will not be able to add laundry. You can only add laundry when the Stop&Add lamp is
illuminated.
1. Press the Stop&Add button.
The washing machine will automatically pause.
2. Wait about 30 seconds and check the state of “Stop&Add” lamp.
• Blinking: The water in the washing machine is drained down to the safety level for the
additional laundry to be added.
• Off: Adding laundry is possible.
3. Add the laundry.
4. Press the Start/Pause button.
• Avoid adding laundry when the machine has foamed up or is fi lled with water. Otherwise,
the foam or water may leak from the door. Check before opening the door.
• We recommend that you select the Stop&Add function 5 minutes before a cycle is
performed.
• If the internal temperature is higher than 55 ˚C during the wash cycle or 70 ˚C during the
drying cycle, the Stop&Add function cannot be selected.
• Do not open the door by force as it may result in injury or damage the washer.
washing a load of laundry
3 SEC.
WARNING
WD8122CVB-02574C_EN.indd 20 2008-06-05 ¿ÀÈÄ 2:09:45