Filter
Top Products
Before first use
1 Check if the voltage indicated on the type plate corresponds to
the local mains voltage before you connect the appliance.
C
2 Remove any sticker or protective foil from the soleplate.
3 Heat up the iron to maximum temperature and pass the iron
over a piece of damp cloth for several minutes to remove any
residues from the soleplate.
The iron may give off some smoke when you use it for the first time
This will cease after a short while.
Preparing for use
Filling the water tank
1 Remove the mains plug from the wall socket.
C
2 Set the steam control to position O (= no steam).
3 Open the filling cap.
(types GC2225, GC2220, GC2215,GC2130, GC2125, and GC2120
only)
4 Tilt the iron.
C
5 Use a measuring cup to fill the water tank up to maximum
level.
6 Close the filling cap (click!).
(types GC2225, GC2220, GC2215,GC2130, GC2125, and GC2120
only)
If the tap water in your area is very hard, we advise you to use distilled
water. Do not use vinegar, starch or chemically descaled water.
Do not fill the water tank beyond the MAX indication.
Setting the temperature
1 Put the iron on its heel.
C
2 Set the temperature dial to the required ironing temperature
by turning it to the appropriate position.
- Check the garment label for the required ironing temperature.
- 1 Synthetic fabrics (e.g. acrylic, viscose, polyamide, polyester)
- 1 Silk
- 2 Wool
- 3 Cotton,linen
ENGLISH 7