Auto-Lift system
Simply touch the iron handle and the iron
will sense your hand and lower. Any time
you release the handle the spacers will
automatically raise the iron to protect your
fabric.
overriding the Auto-Lift
TM
system
TM
To operate, place the iron on its soleplate on
a flat surface. Plug the iron into an outlet and
make sure the Auto-Lift
TM
switch is in the on
( ) position.
If you wish to turn off the Auto-Lift
TM
system, move the switch on the back of the iron to the
off ( ) position. Your Touch&Glide
TM
will now operate like a standard iron. If the iron is left
in the horizontal position for more than 30 seconds, the Auto-Lift
TM
spacers will raise. This will
prevent the iron from burning your fabric or ironing surface. Touch the iron handle and the
iron will lower. You can restore Auto-Lift
TM
by returning the switch to the on ( ) position.