Filter
Top Products
8
OPERATION
OPERATION
Operation Summary
The following is a summary of your Glasswashing Machine operating cycle:
1. The cycle begins when you close the door and push the cycle switch.
2. The green cycle lamp lights and the pump starts.
3. The pump runs during the wash cycle.
4. The pump stops, and the drain valve is opened.
5. After a 2-3 second pause, the pump drain cycle begins.
6.
After a 2-3 second pause, the fill valve opens, and the pump starts for the rinse cycle.
7. When the rinse cycle is complete, the pump stops, the green cycle lamp turns off, and the
cycle is complete.
8. Open the door and remove the rack of clean ware.
Operation Procedures
The operation of your glasswasher will be more efficient when these procedures are followed:
1. Check that the spray arms and scrap basket are in place.
2. Close the door(s). Push the
ON/FILL switch to the ON position. The tank will begin filling
with water. This procedure is followed only when the tank is empty.
3. When the tank is full, check the wash tank temperature gauge. Minimum wash temperature
is 140°F/60°C.
4. Scrap all glasses to be washed, and load the glasses into the rack. DO NOT OVERLOAD
THE RA
CK
.
5. Open the door and insert the rack into the machine.
6. Shut the door, push cycle switch. This will start the wash cycle. The green cycle lamp
located on the front control panel will light. This lamp will remain on until the entire wash
and rinse cycle is completed.