Filter
Top Products
J5 5
INSTALLATION
INSTALLATION
Unpacking
WARNING:
Care should be taken when lifting the machine to prevent damage.
1. Immediately after unpacking your machine, inspect for any shipping damage. If damage is
found, save the packing material and contact the carrier immediately.
2. Remove the glasswasher from the skid. Adjust the feet if required, then move the machine
to its permanent location.
3. Level the machine (if required) by placing a level on the top of the machine and adjusting
the leveling feet. Level the machine front-to-back and side-to-side.
CAUTION:
After locating your machine, it must meet local health codes.
Electrical Connections
WARNING:
Electrical and grounding connections must comply with the National Electrical Code
and/or Local Electrical Codes.
WARNING:
When working on the glasswasher, disconnect the electric service and tag it to indicate work
is being done on that circuit.
1. The electrician should compare the electrical specifications on the machine to the
electrical power supply before connecting the machine to the incoming service at a
fused disconnect switch.
2. Your machine is already equipped with a 5-foot/1.5m power cord and plug suitable for
115V-15A service.
!
!
!
!