A fault indicator lamp comes on but the wash programme
continues as normal.
Problem Possible cause Remedy
The Water inlet/drain
indicator lamp flashes
during a programme,
but the wash
programme has run
normally.
There is a blockage in
the water inlet.
Check whether:
–
the stopcock is opened
wide enough.
–
the inlet hose is kinked.
The water pressure is
too low.
–
In this case, call the Miele
Service Dept.
The filter in the water
inlet hose is dirty.
–
Clean the filter as described
in "Cleaning and care".
The Water inlet/drain
indicator lamp is
flashing.
There is a blockage in
the water outlet.
– Clean the fluff filter and the
drain pump.
– Has the drain hose been
fitted too high? Max.
delivery head, 1.00 m
The Drying overload
indicator lamp is
flashing towards the
end of a drying
programme.
The load was too
large.
– In future do not exceed the
maximum load. This way
you will avoid:
a) Creasing of
delicate textiles
b) Uneven drying
results / damp laundry
Complete the drying process
using a TIMED DRYING
programme.
The Anti-crease/Finish
indicator lamp is
flashing and the
locked indicator lamp
is on.
The selected
programme was
altered with the safety
lock activated.
See section "Safety Lock".
Problem solving guide
46