Filter
Top Products
Matching the fascia panel to
the height of adjacent drawer
fronts
Spacer bars
The fascia panel can be aligned to
neighbouring drawer fronts by
adjusting the spacer bars.
^ Using a socket spanner, turn
clockwise or anti-clockwise until the
required height is reached.
If necessary individual bars can be
removed or more added.
^
To do this, use the socket spanner to
loosen the nuts.
An adapter kit consisting of spacer
bars and longer screws can be ordered
as an optional accessory. This can be
used to add spacer bars from below up
to a maximum of 25 mm.
After fitting the bars, cut or pinch off
any excess length from the screws.
Removing the spacer bars
All the spacer bars can be removed if
the upper edge of the front panel needs
to be flush with the upper edge of the
machine front directly underneath the
fascia panel. See "Fitting a door front
panel made by another manufacturer".
^
Open the door.
^ Unscrew and remove the 3 screws
(see arrows).
^ Remove all the spacer bars.
The 3 holes which are now free should
be used to screw the front panel to the
machine front later on.
Installation and connection
72