Filter
Top Products
A fault message appears in the display
Message Possible cause Remedy A
2
Fault
Check drainage
system
–
The water outlet is
blocked or
restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump as
described in "Problem
solving guide – Opening
the drum door in the
event of a blocked drain
outlet and/or power
failure".
–
The maximum delivery
head is 1 m.
2
Fault
Water intake
Open stopcock
The water inlet is
blocked or restricted.
Check whether
– the stopcock is opened
wide enough.
– the inlet hose is kinked.
– If the fault message
appears again, contact
the Miele Service Dept.
L
Waterproof system
activated
Close the stopcock
The water protection
system has reacted.
– Close the stopcock.
– Contact the Miele Service
Department.
;
Technical fault
Call Service.
There is a fault. Start the programme again.
If the fault message
appears again, contact the
Miele Service Department.
Check detergent
Excessive foam has
built up during
washing.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.
Hygiene info
See "Cleaning the drum (Hygiene info)" in "Cleaning
and care" for further information.
A To delete the message from the display switch the machine off using the On/Off
button K.
Problem solving guide
57