Filter
Top Products
What to do if . . . ?
What to do if, . . . Cause . . . Remedy . . .
. . . the “Soak/Pre-wash” or
“Main wash” or “Rinses 1-2”
or “Rinse 3” LED is flashing?
There is a fault.
– Start the programme again.
If the LED starts flashing
again call the Service Dept.
. . . The “Rinse hold” LED is
flashing?
The spin speed selector has
been set to “Rinse hold”.
– Select a spin speed setting.
. . . The “Final spin” LED is
flashing?
The final spin has not taken
place. The machine detected
an imbalance.
– Loosen the laundry load.
– The spin speed appropriate
for the programme should
be selected.
– Turn the programme
selector to “Spin”.
. . . The “ON” LED is flash-
ing?
Programme locking is
activated. The programme
selected has been changed.
– Go back to the programme
originally selected.
. . . The washing has not
been spun satisfactorily?
The spin speed selected was
too low.
– Select a higher spin speed
next time.
The load was not distributed
sufficiently evenly in the drum.
Laundry was either only spun
at a reduced speed to protect
the machine
– Mix large and small items in
a load to avoid imbalance.
The drain pump and fluff filter
is clogged.
– Clean the drain pump and
fluff filter.
. . . The machine shakes
during the spin cycle?
The four feet are not resting
evenly on the floor.
– Level the machine (see
Installation Section).
28