Filter
Top Products
What to do if . . . ? Problem solving guide
Repair work to electrical appliances should only be carried out by a suitably
qualified person in accordance with local and national regulations. Unauth-
orised repairs could be dangerous.
What to do if, . . . Cause . . . Remedy . . .
. . . The programme does
not
begin?
There is no power.
The "ON" LED has not lit up.
Check that..:
– the door is properly closed.
– the mains plug is plugged in.
– the fuse or circuit breaker
has not tripped.
There is power and the "ON"
LED is lit up, but the
proramme selector has not
been turned to the "Finish /
Start" position.
– Turn the programme
selector to the "Finish / Start”
position.
– Select a programme.
. . . The "Check water inlet /
outlet" LED’s are flashing?
The water inlet is blocked.
The "Check water inlet" LED is
flashing, but the programme
has run normally?
– The stopcock is not opened
far enough.
– The inlet hose is kinked.
– The water pressure is too
low. Call the Service Dept.
The water inlet system is
blocked.
The "Check water inlet" LED is
flashing and the "Finish" light is
on in the Sequence display
but the load in the machine
has not been washed.
– Turn the programme
selector to the "Finish / Start"
position.
– Open the stopcock.
– Select a programme.
The water outlet is blocked.
The "Check water outlet" LED
is flashing.
– Clean the drain pump and
fluff filter.
– Has the drain pump been
fixed too high? (max drain
head 1 metre).
The Waterproof system has
reacted.
The "Check water inlet / outlet
LEDs" are flashing.
– Call the Service Dept.
27