Filter
Top Products
What to do if, . . . Cause . . . Remedy . . .
. . . one of the following
lights is flashing:
– “Soak / Pre-wash”
– “Main wash”
– “Rinses 1 - 2”
– “Rinse 3”
There is a fault. Start the programme again. If
the light starts flashing again,
call the Service dept.
. . . the “Rinse hold” light
flashes?
The spin speed selector has
been set to “Rinse hold”.
Select a spin speed setting (or
Without final spin).
. . . the “Drain/Final spin”
light is flashing:
The final spin has not taken
place The machine detected an
imbalance.
– Loosen the laundry load.
– Turn the programme selector
to “Spin”.
– The spin speed appropriate
for the programme should be
selected.
. . . the “ON” indicator light
is flashing:
Programme locking is activated.
There was an attempt to alter
the programme.
Reselect the programme
originally chosen.
. . . the washing is not spun
satisfactorily:
The spin speed selected was
too low.
Select a higher spin speed next
time.
The load was not distributed
sufficiently evenly in the drum.
Laundry was spun at a reduced
speed to protect the machine.
Mix large and small items in a
load to avoid imbalance.
The fluff filter is clogged. Clean the fluff filter.
. . . the machine shakes
during the spin cycle:
The four feet are not resting
evenly on the floor.
Level the machine (See Section
on Installation).
. . . the light rings do not il-
luminate:
The bulb has gone.
(This in no way affects the
machine’s function).
Changing the bulb requires a
Service call.
. . . in spite of adequate
water supply the water flows
slowly into the machine:
The filter in the water inlet
system is blocked.
Clean the water inlet filter.
Problem solving guide
30