Filter
Top Products
Decor panel dimensions
(The figures given in brackets indicate
the tolerance level in mm.)
Width: 587 (-1) mm
Height: 602 (-1.5) mm
Thickness: 1 (+0.5) mm
Panels more than 1.5 mm thick require
an “adapter strip for a 4 mm thick
decor panel”. This is available from
your Miele Dealer or the Spare Parts
Department.
Note: The decor panel height required
for the adapter strip must not exceed
596.5 (- 1.5) mm.
Fitting a plinth facia
The appliance plinth below the door
can be concealed using a plinth facia.
The height and return of the appliance
cannot be altered.
A taller plinth facia can only be in-
stalled if the overall niche height is
greater.
Plinth height 100 mm (standard)
Niche height 820 mm:
Plinth height 150 mm
Niche height 870 mm: a raising kit is re-
quired.
Plinth height 200 mm
Niche height 920 mm: two raising kits
are required.
A plinth facia (60 cm long) can be or-
dered from your kitchen Dealer or
manufacturer. For Miele kitchens
please quote the model number when
ordering. Before installing the plinth
facia:
The flap(s) in the appliance plinth
must on no account be covered
over.
Installation:
Stick the velcro fastener provided to
the appliance plinth.
For this the following procedure is rec-
ommended:
Match up the hooked side and the
looped side of the velcro fastener
lengthwise.
Cut into 2 or 3 pieces.
Peel off the protective backing from
one of the velcro fastener pieces.
Position the cut pieces along the ap-
pliance plinth, at the left and right
hand edge, and in the middle. Press
firmly into place.
Now peel the protective backing off
the other velcro fastener piece.
Address the plinth facia to the ad-
hesive backing on the velcro and
press firmly into place.
Installation
40