Filter
Top Products
IAdd detergent
It is important to dispense the correct
amount, because . . .
. . . too little results in the following:
–
Laundry will not be properly clean
and will in time become grey and
hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater
elements.
. . . too much results in the following:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an
additional rinse cycle will
automatically switch in).
– A burden to the environment.
Liquid detergent
Liquid detergent should be dispensed
using a ball provided by the
manufacturer for programmes without a
pre-wash.
For programmes with a pre-wash you
will need to purchase a special
container from the Miele Spare Parts
department which sits in the main wash
compartment j of the detergent
dispenser drawer. Add liquid detergent
to this container for the main wash and
to compartment i for the pre-wash.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Detergent for Pre-wash
(if selecting Pre-wash, add
1
/
4
of the total amount recom-
mended). This compartment is
also used for starch formula-
tions when starching separately.
j = Detergent for the main wash
including Soak
§ = Fabric conditioner or liquid
starch.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
How to wash correctly
25