Filter
Top Products
Hot and cold water connection
^
Connect the cold water intake hose
(blue mark) to the cold water valve
and the hot water intake hose (red
mark) to the hot water valve.
Do not connect the washer to hot
water only.
^
Turn on the valve(s) and check for
leaks. The water pressure must be
within 15 -145 psi (1 -10 bar). If the
water pressure is greater that 145 psi
(10 bar) a pressure reducer must be
installed. If the water pressure is
below 15 psi (1 bar) there will not be
enough water available for a
complete fill.
The water intake hoses are equipped
with screen filters. Do not remove these
filters except for cleaning.
Tips for a hot water connection
The hot water temperature from the hot
water valve must not exceed 140°F
(60°C); the ideal temperature is 130°F
(55°C).
Cold water only connection
The washer must be reprogrammed for
cold water only.
^
Press and hold the "Sensitive" button
until the display reads:
Water intake
Hot + cold (
+ OK
^
Press the "+" button until cold
appears in the display. Confirm by
pressing the OK button.
^ Attach a Y adapter to the cold water
valve.
^ Attach both the hot and cold water
intake hoses to the Y adapter.
Both hoses must be connected to a
water source or the machine will not
function properly.
Plumbing
47