Filter
Top Products
Installation
Installing the front panel
A front panel must be installed on the
washer before it can be safely oper-
ated. It can be custom made to match
the surrounding cabinetry or furmiture.
Front Panel Dimensions:
Height: 22
7
/16" (+
3
/8" / -1")
570 mm (+ 10 / - 25 mm)
Width: 23
3
/16" – 23
1
/2"
588 – 596 mm
Thickness:
3
/4" (19 mm) maximum
Using the provided template, layout
and drill the pilot holes for the mounting
brackets as follows:
Lay the panel with the finished side
face down and the bottom edge to-
ward you.
Align the bottom of the template with
the lower edge of the door.
Center the template on the panel by
using the four parallel lines located
at each corner. The panel is cen-
tered when the identical line on each
side aligns with the panel edge.
For example, if your panel is 23
3
/8"
wide, the second line from the center of
the template will align with both the
right and left edges.
Tape the centered template to the
panel.
Using a
3
/8" (10 mm) drill bit, drill
1
/2"
(12 mm) deep pilot holes at tem-
plate locations 1 and 2 only.
Remove the template from the panel.
Installation
36