Filter
Top Products
Fault messages in the display
Problem Possible cause Remedy A
2
Fault
Check drainage
system
–
The water outlet is
blocked or
restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum delivery
head is 1 m.
2
Fault
Water intake
Open stopcock
The water inlet is
blocked or restricted.
Check whether
–
the stopcock is opened
properly.
–
the inlet hose is kinked.
L
Waterproof system
activated
Close the stopcock
The water protection
system has reacted.
Call the Service
Department.
;
Technical fault.
Call the Service
Department
There is a fault. Start the programme again.
If the fault message
appears again, contact the
Service Department.
The following flashes in
the display:
Anti-crease
alternately with
Check detergent
Excessive foam has
built up during
washing.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.
A To switch off the fault message: Switch the machine off with the I-On/0-Off
button.
Problem solving guide
42