Filter
Top Products
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the tumble dryer is tipped up
when it is being moved. It is a good
idea to run the Cool air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
Installation site
,
Make sure the dryer door can be
opened without hindrance after
installation.
,
The cool air intake panel at the
front of the dryer must not be
blocked or covered, e.g. by a
laundry basket, as this would cause
a fault.
Building under a continuous worktop/
in a row of kitchen units
,
It is very important to avoid a
build-up of heat.
The warm air which is expelled from
the rear of the dryer must be able to
dissipate.
Warm air which cannot dissipate
could cause a fault.
A build-up of heat can be avoided by:
–
Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floor and the bottom of the dryer.
–
Creating a gap for the dryer in the
kitchen furniture plinth facing.
–
Creating ventilation gaps in the
kitchen unit.
N.B. When built under, drying times
may be longer.
,
The dryer should not be installed
next to a refrigeration appliance. The
warm air expelled from the rear of
the dryer would increase the
temperature around the refrigeration
appliance's heat exchanger causing
the compressor to run continuously.
If it is not possible to install the dryer
anywhere else, then the refrigeration
appliance must be sealed off from
the dryer.
,
A building-under kit (Miele
accessory, available to order) with a
coverplate to replace the
appliance´s lid is required. It must
be fitted by a suitably qualified
person to ensure electrical safety.
N.B. If you wish to push the tumble
dryer under a worktop and there is
space to do this without removing
the lid the building-under kit is not
necessary. Otherwise the
building-under kit is essential.
Installation
44