Filter
Top Products
Problem Possible cause Remedy
The following
message appears
after the programme
has finished:
Clean fluff filters
The dryer is not
working efficiently or
economically.
Possible causes: The
fluff filters are
clogged with fluff or
with detergent
residues.
–
Clean the fluff filters.
If they need to be cleaned
with water, make sure they are
completely dry before
replacing them.
–
See also the notes on the next
page under: The drying
process goes on too long or
even switches off.
To delete the fault message:
–
Switch the dryer off and then
back on again.
You can adjust the
setting which controls
when or if the
message
Clean fluff
filters
appears.
See Settings menu J, Airways
indicator section.
,
TECHNICAL FAULT!
– the programme is
cancelled.
– the buzzer sounds
No obvious cause.
In some
circumstances,
Clean
fluff filters
will already
have been displayed.
– Clean the fluff filters and the
condenser unit.
To delete the fault message:
– Switch the dryer off and then
back on again.
There is a fault, if
despite doing this,
the programme is
cancelled and the
fault message
appears again.
Contact the Miele Service
Department.
Problem solving guide
34