Filter
Top Products
^
Then flush the unit through from the
front.
^ Check the condenser unit again for
any visible fluff and if necessary flush
it through again until it has all gone.
^ Remove any soiling still visible inside
the housing unit.
^ Also make sure the rubber seals are
clean.
The rubber seals must not be
removed and must be free of kinks.
^
Shake any excess water out of the
unit until no more water droplets are
visible.
Replacing the condenser unit
^
With the handle facing upwards,
push the condenser unit back into
position in its housing.
^
Turn the lever down to the horizontal
position, making sure that the hook
on the lever clicks into the groove.
When replacing the cover after
cleaning, ensure that the rubber seal
fits correctly into the groove.
^
Replace the cover making sure the
hooks locate correctly. Hold it at an
angle and push it gently downwards.
^ Then turn the lever upwards into the
horizontal position to lock the cover.
^ Replace the service panel and press
the upper edge until it clicks into
position.
It is important to ensure that both the
condenser unit and the cover are
correctly positioned and locked.
Otherwise water may leak from the
machine.
Cleaning and care
32