Filter
Top Products
Problem Possible cause Remedy
The
Anti-crease/Finish
indicator light
flashes while drying
is in progress.
The programme selector
was moved after the start of
a programme. The
programme continues to
run as normal.
Turn the selector back to the
original position and the
indicator light will go out.
The programme
stops and the
Machine iron or
Hand iron indicator
light flashes. The
buzzer sounds.
No obvious cause.
–
Switch the dryer off and
then on again.
–
Then start the programme
again.
If the programme stops
again and the indicator light
flashes again there is a fault.
Contact the Miele Service
Department.
The programme
stops and the
Anti-crease/Finish
indicator light
comes on. 0 will
appear in the
display. The buzzer
sounds.
This is not a fault. The
electronic unit has
recognised that there is no
laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be
cancelled.
– Use the Timed drying -
Warm air programme to
dry individual items.
– The indicator light will go
out when you open and
close the door, if the
dryer is switched on.
The time remaining
pauses. Bars =...-...
appear in the
display.
This is not a fault.
The drying process is not
yet complete.
The programme has taken
longer than was estimated
at the beginning.
The adjusted time remaining
will appear in the display
after a while.
The Locked
indicator starts
flashing after the
dryer has been
switched on. A
programme cannot
be started.
The system lock is
activated.
You will need to deactivate
the system lock before the
dryer can be used (see
"Electronic system lock").
Problem solving guide
32