Filter
Top Products
G Start the programme
^
Press the
Start
button.
–
The indicator light for the
Start
button
will then change from flashing to
being on constantly. The drying cycle
begins.
–
Depending on the programme
selected, the drying stage reached is
shown by the sequence indicator
lights on the right hand side of the
control panel.
Before the end of a programme
The cooling down phase takes place
before the end of a programme so that
the garments are not too hot to handle
(the
Cool air
indicator light will come
on). The programme is not finished until
the cooling down phase is complete.
The
Woollens hand care
and
Smoothing
programmes do not include
a cooling down phase.
At the end of a programme
The
Anti-crease/Finish
indicator light
comes on. 0 will then appear in the
display.
The drum will continue to rotate at
intervals to prevent laundry creasing, if
you do not wish to remove it immediate
-
ly (anti-crease). The anti-crease phase
lasts for an hour.
H Remove the laundry
^
Press the
Door
button and open the
door.
^
Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^
Switch the dryer off by pressing the
l-On/0-Off
button.
^
Clean the fluff filters in the door and
the door opening after each drying
programme.
^ Close the door.
^ Empty the condensed water
container (where there is no external
drainage of the water).
^ The condenser unit should be
checked and cleaned on a regular
basis.
Check lights
... See "Problem solving guide" for
details.
How to dry correctly
15