Filter
Top Products
~
The dryer must not be used without
the fluff filter in place or if the fluff filter is
damaged in any way.
~
The fluff filter must be cleaned
regularly.
~
The tumble dryer must not be used
without vent ducting in place.
~
The tumble dryer must not be
connected to a chimney or vent flue
which is in use.
~
Do not install the tumble dryer in a
room where there is a risk of frost
occurring. At temperatures around
freezing point the tumble dryer may not
be able to operate properly.
The ambient room temperature should
be between +2°C and +35°C
~
Check all parts of the extraction
system on a regular basis (e.g. wall
vent, external grille, bends in the
ducting etc.) and make sure they are all
free of any hindrance. A build-up of fluff
will prevent a free flow of air through the
system. If the dryer is to be connected
to an existing ducting system, this must
be checked for suitability beforehand.
~
The exhaust air must not be vented
into a chimney or vent flue which is in
use, nor should it be connected to
ducting which ventilates rooms with
fireplaces. It would be dangerous if
smoke or exhaust fumes were drawn
back into the room.
~
Adequate ventilation is essential to
avoid the danger of asphyxia and
toxic fumes where another appliance
which also uses the room air (e.g. gas,
oil or coal fired heater, continuous flow
or other water heater) is installed in the
same or an adjacent room.
To ensure safe operation, and to
prevent gases given off by these
appliances being drawn back into the
room, an underpressure of 0.04 mbar is
the maximum permissible.
Ventilation can be maintained by:
–
air inlets in the external wall which
cannot be closed or blocked, or
– by fitting a window contact switch
which ensures that the tumble dryer
can only be operated when the
window is opened wide enough.
If in doubt, the advice of a competent
builder must be sought.
~
The room in which the dryer is
installed must be clean and free of dust
and fluff.
Particles of dirt entering the dryer can
lead to blockages occurring.
Warning and Safety instructions
8