Miele 05 993 050 Washer/Dryer User Manual


 
Problem Possible cause Remedy
The programme has
been interrupted,
the indicator lamp
for Hand iron or
Machine iron is
flashing, and the
buzzer sounds.
No obvious cause.
Switch the dryer off and
then on again.
Then start the programme
again.
If the programme stops
again and an indicator lamp
flashes, there is a fault.
Contact the Miele Service
Department.
Check and fault indicator messages in the display
After the beginning
of the programme
the following
symbols flash in the
display: "=== ... -== ...
== ... ".
This is not a fault. The electronic unit is
calculating the drying time
for the programme (see
“Guide to the appliance”).
Shortly before the
end of the
programme, the
count down of the
time left to run halts
at 11 or 6, horizontal
bars flash but the
dryer continues to
dry.
This might be because:
items of laundry may
have rolled up together.
the types of fabrics being
dried may take different
times to dry.
the fluff filters are
clogged.
the temperature in the
room may have
changed.
The drying process is not
yet complete. The
programme needs more
time than the electronic unit
calculated at the start of the
programme. The time count
down is suspended until the
degree of drying selected
has been reached.
The programme has
been stopped, the
Anti-crease/Finish
lamp comes on, 0
appears in the
display and the
buzzer sounds.
This is not a fault. The
electronic unit has
recognised that there is no
laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be stopped.
Use the "Timed drying -
Warm air" programme to dry
individual items.
Before changing a
programme: Open and
close the drum door.
Problem solving guide
32