Miele 05 993 050 Washer/Dryer User Manual


 
Problem Possible cause Remedy
The condenser unit
service panel will
not shut.
The inner cover of the
condenser unit has not
been locked properly
and/or the condenser unit
has not been positioned
correctly.
Ensure that the condenser
unit is positioned correctly
and lock the cover.
Check the rubber seals.
Water leaks from the
machine after the
condenser unit has
been cleaned.
Fluff has collected at the
bottom of the condenser
unit housing.
Use a cloth to remove any
fluff from the inside of the
condenser unit housing.
The interior drum
lighting does not
come on.
The lighting switched off
automatically.
The lighting only comes on
when the door is opened if
the dryer is switched on. To
save energy the lighting
goes out after a while if the
door is left open.
The lamp needs changing. Change the lamp as
described at the end of this
section.
The ring around the
programme selector
does not light up.
The lighting switched off
automatically.
It lights up when drying is in
progress and goes out
shortly after the end of the
programme to save energy.
Check and fault indicator lamps
Problem Possible cause Remedy
The Anti-crease /
Finish indicator
lamp flashes while
drying is in
progress.
The programme selector
was moved after the start
of a programme. The
programme continues to
run as normal.
Turn the selector back to the
original position and the
indicator lamp will go out.
The Locked
indicator lamp
flashes when the
machine is switched
on and the
programme cannot
be started.
The system lock is
activated.
If you wish to use the dryer,
the system lock must be
deactivated (see "Electronic
system lock").
Problem solving guide
30