Mellerware 23810 Iron User Manual


 
Tips and safety warnings
-This appliance is not intended for use by
persons(including children)with reduced physi-
cal, sensory or mental capabilities, or lack of ex-
perience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
-Children should be supervised to ensure that they
do not play with the appliance.
-Please read these instructions carefully before us-
ing the appliance and keep them for future refer-
ence.
-Unpack the appliance and check it is in perfect
condition and working order, as any factory fault
or damage caused by transport is covered by the
MELLERWARE guarantee.
-This device has been designed for household
use, not for commercial use.
-Do not leave the appliance without supervision if
you are not going to use it immediately. This will
save energy and prolong the working life of the
appliance.
-Keep the appliance out of the reach of children.
-The appliance must not be connected to the
mains while the boiler is being filled (Fig. 1).
-Before connecting the appliance to the mains, en-
sure the supply voltage is the same as that marked
on the appliance. The water filling inlet must not
be open during operation.
-This appliance must be connected to an electrical
socket with an earth connection.
-Any improper use or failure to comply with the in-
structions for use will invalidate the warranty and
free the manufacturer from any liability
concerning the appliance.
-IF THE IRON IS IN ITS HOUSING AT MAXIMUM
TEMPERATURE FOR A LONG TIME, IT MAY DIS-
COLOUR, BUT THIS HAS NO EFFECT ON THE
PROPER OPERATION OF THE APPLIANCE.
- The appliance must be used and placed on a flat,
stable surface
- When placing the appliance on its support, make
sure the surface on which the support is fitted is
stable.
- Do not use the appliance if it has been dropped,
if there are visible signs of damage or if it leaks.
Before using the appliance for the first time
This professional iron works with tap water.
However, the use of distilled water is recomended
in areas with a high lime level in the water. Some
parts of the iron have been slightly greased.
They can therefore give off steam on first use, but
this steam will disappear after a short time.
Practical tips
-Keep the sole plate smooth, do not apply it to
metallic objects (i.e., to the ironing-board, butons,
zips...).
-Fit the iron in its housing (L) for transport and stor-
age, in order to improve its stability.
-To avoid burns, do not lean Bravissimo 2 Pro’s
iron on its back.
Steam ironing
When you start to iron, proceed as follows:
-Unscrew the cap (F) and fill the boiler with water,
using a jug (Fig. 1) (if you fill it with hot water, the
appliance will be ready for use sooner).
-Even if the boiler has a certain level of water, it is
always recommended to fill it to the top for a longer
range, thanks to its large 1l capacity.
-Carefully close the cap (F), screwing it to the end.
-Place the boiler on a flat , stable surface.
-Plug the appliance into the mains.
-Switch on the boiler and the iron by pressing the
relevant switches (B) and (A). The corresponding
LEDs will light (Fig. 2).
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 4MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 4 11/17/2009 12:49:22 PM11/17/2009 12:49:22 PM