Filter
Top Products
19
To restart your dryer
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Pus
h the START button.
Drying Rack Option
Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum
turns, but the drying rack does not move.
I
f your model does not have a drying rack, you may be able to purchase one for your model. To
find out whether your model allows drying rack usage and for information on ordering, please
refer to the front page of the manual or contact the dealer from whom you purchased your dryer.
NOTE: The drying rack must be removed for normal tumbling. Do not use the automatic cycle
with the drying rack.
To use the drying rack
1. Plac
e drying rack in dryer.
Style 1: Your drying rack has front legs. Slide rear pegs into the dimples on the back wall of
the dryer. Lower the front legs to rest on the dryer opening.
Style 2: Y
our drying rack does not have front legs. Do not remove the lint screen. Slide
drying rack over the bottom of the dryer door opening. Push down to secure drying rack on
frame.
2. Put wet ite
ms on top of drying rack, leaving space between items. Do not allow items to
hang over the edge of the drying rack. Close the door.
3. Selec
t a timed drying cycle and temperature, or an air cycle. Items containing foam,
rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the
following table.
4. Start the dry
er. Reset cycle to complete drying, if needed.
Rack Dry Cycle Temp Time
Washable wool items (block to shape, lay flat on
drying rack)
Timed
Drying
Low 60 min.
Stuffed toys/pillows (cotton or polyester filled) Timed
Drying
Low 60 min.
Stuffed toys/pillows (foam rubber filled) Air
(no heat)
N/A 90 min.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
Cleaning the Lint Screen
Clean lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every Load Cleaning
1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off
the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard
to remove.
2. Push the lint screen firmly back into place.
As Needed Cleaning
1. Roll lint off the screen with your fingers.
2. W
et both sides of lint screen with hot water.